operate

How to make a Bale - Quick Tutorial



Sharing buttons:

after you determine the bailer is

operating properly you can prepare to

make a bail prepare as follows ensure

the key is in the off position check

that the RAM is in the raised position

with the safety gate in its up position

open the chamber door

place a flat piece of cardboard on the

bottom of the chamber over the ejecting

chains then close the baler chamber door

fully you are now ready to begin baling

take the following steps to make a bail

fill the chamber evenly with material

boxes do not need to be broken down the

material should be loaded evenly in the

chamber to insure the baler produces a

uniform cardboard bail do not reach into

the chamber to move or remove material

when loading carefully pull the safety

gate all the way down engaging the RAM

safety switch keep hands away from the

top of the baler door while closing set

the power switch to the on position

press the up down selector button either

position will start operation the rim

will travel down compressing the

material the RAM will reverse when the

full down stroke pressure is reached and

automatically opened the feed gate as to

ram a sense to the full up position the

machine is now ready to accept more

material repeat these steps until the

arrows on the RAM face and sidewall

match as the RAM reverses or full bail

indicator light illuminates you are now

ready to tie off and eject the bail from

the machine this can be accomplished by

taking the following steps use

appropriate personal protective

equipment PPE as stipulated by company

policy when working with baling wire

PT R recommends safety glasses and

forearm length gloves when working with

baling wire when the full light

illuminates the machine will stop with

the RAM against the compressed bail and

be operable only in manual control mode

set the up-down switch to up press and

hold the star button to raise the RAM

turn the key switch to the off position

with the RAM in the up position insert a

flat piece of cardboard on top of the

Bale pull the safety gate to the down

position turn the key switch to the on

position set the up-down switch to down

then press and hold the start button

this will provide flat surface for time

when the RAM cannot compress any further

stop then turn off and remove the key at

this time the yellow arrow should at

least be aligned with the arrow on the

frame if the RAM is lower than the mark

it is still safe to eject the veil never

try to reject the bail when the

alignment arrow on the RAM is above the

alignment arrow on the frame failing to

do so will result in damage to the feed

gate unlatch and open the chamber door

more than 90 degrees with the chamber

door open the machine will be operable

only in manual control mode slide baling

wire into the front slots located in the

RAM a minimum of 4 baling wires should

be used and back out through the slots

in the bottom of the floor of the baler

tie off all of the baling wires

[Music]

position a pallet hand truck or forklift

in front of the baler opening to receive

the bail when it is ejected place the

ejector chains on the RAM ejector hooks

and the back of the baler carefully pull

the safety gate all the way down

engaging the RAM safety switch be sure

the door is opened more than 90 degrees

insert the key and turn the switch to on

set the up/down switch to the up

position stand clear of the opening when

the bail is being ejected press and hold

the up switch until the Bailee jacks