How to bleed Hot Water System
How to Get Air Out of the Lines for the Hot Water Heater : Water Heaters
0:00 / 0:00
Quality:
Sharing buttons:
[Music]
hello everyone I'm Joshua little flighty
contractors and today I'm going to talk
to you about how to get the air out of
your lines for a hot water heater to
start off with when you're filling your
hot water heater after you've installed
it there's this thing right here this is
actually a Popoff when your water gets
too hot it'll start popping it and water
will start coming down your pipes and
into your drain but it also works great
to allow the air to get out of your tank
that way the more water can come in and
actually the only area you'll have to
get out is in the lines above so to
start with you're going to pop this here
and you'll hear it going and that's all
the air coming out of it you want to
make sure that this is shut off when the
water level starts getting up here and
actually starts coming out of the pipe
that way it's not just running water all
over place the next step is actually at
your sink what you're going to do there
is turn on your hot water at your
bathroom sink at your kitchen sink and
probably in the shower too what it's
going to do is going to start spitting
some air out in a little bit of water
and you want to do this until you have a
nice steady stream coming out it'll
probably look a little funny colored you
want to let all that pass through that
until you have a nice clear water coming
out I'm Joshua Clement flatty
contractors and you just learned how to
get the air out of your lines for a new
hot water heater thanks for watching and
good luck with this project
[Music]
you
